Audi A4, S4
+ Introduction
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
- Body
General information and security measures when carrying out body works
Cleaning and leaving
Repair of insignificant damages of body panels
Repair of considerable damages of a body
+ External equipment
- Equipment of salon
Remarks on work with the equipment of salon and a security measure
Removal and installation of spring clips
Removal and installation of the central console
Removal and installation of the holder of drinks
Removal and installation of facing of the lever of the parking brake
Removal and installation of a cover of the lever of switching of transfers/selector
Removal and installation of an ashtray
Removal and installation of the central armrest
Removal and installation of an internal mirror
Removal and installation of a cover on a control panel
Removal and installation of a pocket from the driver
Removal and installation of a ware box
Removal and installation of an antisolar peak
Removal and installation of facing are permanent And
Removal and installation of the top facing of a rack In
Removal and installation of the lower facing of a rack In
Removal and installation of a forward overlay of a threshold
Removal and installation of facings (Sedan)
Removal and installation of facings (Station wagon)
Removal and installation of a forward seat
Removal and installation of a back seat
Removal and installation of a forward seat belt
Removal and installation of a back seat belt
+ Onboard electric equipment
|
Removal and installation of a back seat belt Removal
|
|
- Switch off ignition and disconnect at first the negative (-), and then positive battery cables. Stick the negative plug of the battery with an insulating tape. Instructions are provided in the Section Replacement of the Battery.
-
Sedan: Remove facing of a rack of D, address to appropriate section.
-
Sedan: remove the shelf, address to appropriate section.
-
Sedan: Remove the damping element under the shelf.
- Remove lateral facing of a luggage carrier / a cargo compartment, address to appropriate section.
|
- Turn out the screw (2) at the device for taking-up of a belt (1), and also a bolt (5) at a belt tip.
|
|
- Disunite the socket (7) and disconnect a device cable for a belt tension from the holder (4). (8) – cover of protection against noise.
- Extend the device for taking-up of a belt (1) of lock openings (3) and take out together with a seat belt.
|
|
Installation
|
|
- Installation is carried out in sequence, the return to removal. Thus watch the correct laying of a cable of a belt. Tighten bolts (2) and (5) moment 55nm.
|
|
During connection of the battery in salon there should not be people. |
- Remove the isolating tape from a negative pole of the battery, attach at first positive (+), and then a negative cable (-) to the battery.
|
|
Back directing a belt
Removal
Installation
|
|
- Installation is carried out in sequence, the return to removal. Thus both washers (3) have to lie over lock openings. Directing for a belt it has to be recorded distinctly.
|
|
|
|