Audi A4, S4

since 2000 release

Repair and operation of the car

Removal and installation of facing are permanent And

Removal

PERFORMANCE ORDER

At a detachment of cables of system of a safety cushion surely observe security measures at the address with a safety cushion, address to the Section General information and security measures.

To exclude operation a head safety cushion, switch off ignition and disconnect at first the negative (-), and then positive battery cables. Instructions are provided in the Section Replacement of the Battery.

Remove a solar peak, address to appropriate section.

Press down the handle (5) and cast away a screw cover (4) down. For this purpose enter (7) thin wire into a groove and open a cover.

Turn out screws (2).
Take out a cover (9) of facing (1) and turn out the screw which is behind it.
Disconnect facing (1) at spring clips (3) grooves (6) in a rack And and extend under facing of a rack of Century.
Remove from the dashboard facing of a rack A (1) back.

Installation

PERFORMANCE ORDER

Insert facing under consolidation of a door (8) and press the directing pad (10) in the holder of a clip. Thus watch the correct provision of a sealant of a door.
Press facing at spring clips (3) and record.
Insert facing of a rack And under facing of a rack of Century.
Check that the clip and hooks of the adapter of a safety cushion were reliably recorded.
Screw the screw behind and press a cover (9) into facing.
Fix the handle the new self-stopped screws (2). Close a screw cover.

During connection of the battery in salon there should not be people.

Remove an insulating tape from the negative plug of the battery, attach at first positive (+), and then a negative cable (-) to the battery.

Observe indications of the Section Replacement of the Battery.