Audi A4, S4

since 2000 release

Repair and operation of the car


Audi A4, S4
+ Introduction
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
- Body
   General information and security measures when carrying out body works
   Cleaning and leaving
   Repair of insignificant damages of body panels
   Repair of considerable damages of a body
   + External equipment
   - Equipment of salon
      Remarks on work with the equipment of salon and a security measure
      Removal and installation of spring clips
      Removal and installation of the central console
      Removal and installation of the holder of drinks
      Removal and installation of facing of the lever of the parking brake
      Removal and installation of a cover of the lever of switching of transfers/selector
      Removal and installation of an ashtray
      Removal and installation of the central armrest
      Removal and installation of an internal mirror
      Removal and installation of a cover on a control panel
      Removal and installation of a pocket from the driver
      Removal and installation of a ware box
      Removal and installation of an antisolar peak
      Removal and installation of facing are permanent And
      Removal and installation of the top facing of a rack In
      Removal and installation of the lower facing of a rack In
      Removal and installation of a forward overlay of a threshold
      Removal and installation of facings (Sedan)
      Removal and installation of facings (Station wagon)
      Removal and installation of a forward seat
      Removal and installation of a back seat
      Removal and installation of a forward seat belt
      Removal and installation of a back seat belt
+ Onboard electric equipment





Removal and installation of the top facing of a rack In

Removal

 PERFORMANCE ORDER

At a detachment of cables of system of a safety cushion surely observe security measures at the address with a safety cushion, address to the Section General information and security measures.

  1. To exclude operation a head safety cushion, switch off ignition and disconnect at first the negative (-), and then positive battery cables. Instructions are provided in the Section Replacement of the Battery.
  2. Disconnect facing of a rack And around a rack In, address to the Section Removal and installation of facing of a rack And.
  3. Disconnect facing of a rack D/facing over a back door (Station wagon) around a rack In, address to appropriate section.
  4. Remove a seat belt on a forward seat, address to the Section Removal and installation of a forward seat.
  1. Extend facing (1) of a door sealant.
  1. Disconnect facing (1) at spring clips below (2) and above (5) and (7).
  2. Pull facing (1) down and disconnect from a rack of Century.
  3. Disconnect a seat belt (3) from the regulator of height of a belt (4) and remove facing.

Installation

 PERFORMANCE ORDER

Do not press in an installation time a lock key (6).

  1. Enter a seat belt into the belt height regulator.
  1. Displace a buckle with a key (4), without pressing thus a key, from top to down on the razblokirovochny lever (1) regulator of height and at the same time enter a pin (2) into a groove (3).
  1. Fix facing of a rack In above. Thus lock pads (5) and (7) have to be recorded. Watch the correct gap.
  2. Press below facing by spring clips (2) and record.
  1. Put over facing at the left and on the right a door sealant.
  2. Check operation of the regulator of height: Press and release a lock key. It has to come back to the top situation independently. Displace the regulator of height and fix it. Thus the regulator has to be fixed distinctly on each of five positions. Otherwise remove facing and again connect a buckle to a lock key with height regulator.
  3. Establish a seat belt on a forward seat, address to the Section Removal and installation of a forward seat.
  4. Fix facing of a rack And and facing of a rack D/facing over a back door (Station wagon) around a rack In, address to appropriate section.

During connection of the battery in salon there should not be people.

  1. Remove an insulating tape from the negative plug of the battery, attach at first positive (+), and then a negative cable (-) to the battery.

Observe indications of the Section Replacement of the Battery.