Instruction: Removal and installation on the Sedan models is carried out similarly. Unlike the Station wagon models there are no basic and sealing levels (7), (9), and also a support (14). 1 — Two bolts 2 — Loker of a wing 3 — the Nut 4 — the Nut 5 — Directing 6 — Six clips 7 — the Basic level 8 — the Bolt
9 — the Sealing level. It is inserted into a bumper 10 — the Decorative level. It is inserted into a bumper 11 — the Lateral sealing level. It is inserted into a bumper 12 — the Bumper 13 — Two bolts 14 — the Support. At installation of a new bumper it has to be replaced. 15 — the Shock level Instruction: The shock level is fixed on a rear bumper by a bilateral adhesive tape. Thereof at removal it collapses.
Disunite the loudspeaker socket behind lateral facing and disconnect a loudspeaker together with the amplifier.
Disunite the socket of parking sensors at the control unit under a back lamp.
Turn off nuts (3) and nuts (4) in a cargo compartment.
Turn out bolts (13).
Disconnect a loker of a wing in back part.
Turn out a bolt (1) at directing (5) and remove lateral part of a bumper.
By means of the assistant pull a bumper back and remove it.
Installation
PERFORMANCE ORDER
Installation is carried out in sequence, the return to removal.
At installation of a new bumper establish from below a new support (14). Then release a support, having pulled for a thread. Thus the support unloads and holds a bumper in relation to a cross-piece.
The support is released when the bumper is completely established.