Audi A4, S4

since 2000 release

Repair and operation of the car


Audi A4, S4
+ Introduction
- Governing bodies and methods of safe operation
   Governing bodies and devices
   Information system of the driver (FIS)
   Unlocking and locking of the car
   Lighting and providing review
   Seats and niches
   Heater, ventilation and conditioner of air
   Automatic Transmission (AT)
   Communication and navigation
   Universal remote radio control of HOME LINK®
   Security systems
   Features of operation and auxiliary systems
   Running in
   Towage of the trailer
   In case of emergency
   Gas station of the car
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Seats and niches

Manual adjustment of forward seats

Regulators of provision of a seat

The seat can be regulated in many parameters.

Regulators of a seat of the driver

1 — Longitudinal adjustment of provision of a seat
2 — Seat height adjustment
3 — Adjustment of an exit of a lumbar support *
4 — Adjustment of an inclination of a back

Some of the shown governing bodies are included in the package only of certain modifications or are established to order.

Longitudinal adjustment of a seat

 PERFORMANCE ORDER

  1. Pull the handle (1) up, and thus displace a seat in the necessary situation.
  2. Release the handle (2) and move a seat to a clamp zashchelkivaniye.

Regulation of height of a seat


Lifting of a seat

 PERFORMANCE ORDER

  1. Pull the handle (2) up.


Lowering of a seat

 PERFORMANCE ORDER

  1. Wring out the handle (2) down.

Regulation of an inclination of a back

 PERFORMANCE ORDER

  1. Unload a seat back (do not lean on a back).
  2. Regulate a back inclination rotation of a flywheel (4).

Regulators of provision of a seat (sports seat)

The seat can be regulated in many parameters.

Regulators of a seat of the forward passenger

1 — Longitudinal adjustment of provision of a seat
2 — Lengthening of a pillow of a seat
3 — Adjustment of an inclination of a seat
4 — Seat height adjustment
5 — Adjustment of an exit of a lumbar support *
6 — Adjustment of an inclination of a back

Some of the shown governing bodies are included in the package only of certain modifications or are established to order.

Longitudinal adjustment of a seat

 PERFORMANCE ORDER

  1. Pull the handle (1) up, and thus displace a seat in the necessary situation.
  2. Release the handle (1) and move a seat to a clamp zashchelkivaniye.

Seat pillow


Vydvigany pillows

 PERFORMANCE ORDER

  1. Raise a key (2).
  2. Displace a seat forward and establish a pillow in the necessary situation.


Zadvigany pillows

 PERFORMANCE ORDER

  1. Raise a key (2).
  2. Displace a seat back and establish a pillow in the necessary situation.

Adjustment of an inclination of a seat

 PERFORMANCE ORDER

  1. Pull the handle (3) up and change the provision of a seat, unloading and loading it with a body weight.

Regulation of height of a seat


Lifting of a seat

 PERFORMANCE ORDER

  1. Delay the handle (4) (swing) up.


Lowering of a seat

 PERFORMANCE ORDER

  1. Wring out the handle (4) (swing) down.

Regulation of an inclination of a back

 PERFORMANCE ORDER

  1. Unload a seat back (do not lean on a back).
  2. Regulate a back inclination rotation of a flywheel (6).

Electric adjustment of forward seats

Regulation of provision of a seat

The principle of control of regulators corresponds to a design and function of a seat.

Forward seat: situation regulators

And — Regulation of provision of a seat
In — Adjustment of an inclination of a back
With — Adjustment of an exit of a lumbar support *

Forward seat: regulator

Governing bodies of regulation of provision of seats on the arrangement, design and a functional purpose correspond to a seat design. Regulation of provision of a seat is carried out according to this logic by pressing of switches.

Giving of a seat forward/back

 PERFORMANCE ORDER

  1. Press the switch (A) forward or back (1).

Rise/lowering of a seat

 PERFORMANCE ORDER

  1. Delay/press the switch (And) up or down.

Rise/lowering of forward part of a pillow

 PERFORMANCE ORDER

  1. Press the switch (And) up or down (2).

Rise/lowering of back part of a pillow

 PERFORMANCE ORDER

  1. Press the switch (A) up or down (3).

Regulation of an inclination of a back

Forward seat: back inclination regulator

 PERFORMANCE ORDER

  1. For rise or lowering of a back press the switch forward or back in the directions specified by shooters.

Exit of a lumbar support

 PERFORMANCE ORDER

  1. The exit of a lumbar support provides a support of lumbar department of a backbone of all natural contour.


Camber adjustment

 PERFORMANCE ORDER

  1. For a vydviganiye of an upholstery press the forward party of the large-format button (C).
  2. For retracting an upholstery press on the back party the buttons (C).


Adjustment of height

 PERFORMANCE ORDER

  1. For shift of an upholstery press on the top party the buttons up (C).
  2. For shift of an upholstery press on the lower party the buttons down (C).

The lumbar support provides a prileganiye of lumbar department of a backbone of all its natural contour, with the landing which is not tiring even at long trips.

Memory of provision of a seat of the driver

Description

The keys of a memory located at the driver's doors it is possible to program and reproduce four various versions of the provision of a seat and external zerkal*.

Driver's door: memory

Memory keys

Keys of a memory 1, 2, 3 and 4 it is possible to program and reproduce at most four various versions of the provision of a seat and external zerkal*.

STOP key

The memory of provision of a seat is disconnected by pressing of the STOP key. Thus OFF inscription which is near the STOP key burns (it is visible only at the included light).

All entered provisions remain in memory. The provision of a seat and external mirrors * thus can be regulated only in the usual way - by means of the electric drive. The memory is recommended to be disconnected pressing of the STOP key at incidental use of the car of the driver and therefore lack of need of programming of provision of a seat for it.

The programmed provisions can be reproduced also by means of remote radio control, see below.

Programming of provisions

During the programming and reproduction of all functions it has to be pressed the STOP key (is drowned).

 PERFORMANCE ORDER

  1. Adjust the provision of a seat of the driver, see above.
  2. Adjust the provision of both external mirrors, see Lighting and providing the review.
  3. Press and hold the MEMO key. In addition press and hold not less than 1 second one of memory keys.
  4. Release keys. This situation is entered into memory now and corresponds to number of the key chosen at input.

At each new programming on the same key there is a dumping of the previous data. When programming it is recommended to begin with a key 1, leaving for other drivers on one of other keys.

When locking the car the radio key (remote radio control) into memory enters the last provision of a seat and mirrors. This provision of a seat and mirrors automatically is reproduced remote radio control at the subsequent unlocking of the car. The provision of external mirrors is reproduced right after unlocking, and the provision of a seat of the driver after opening of a door of the driver.

Thus however there is no dumping of data of a memory of the distribution undertaken earlier on keys 1-4. At any time reproduction of the entered provisions by the corresponding keys is possible.

Reproduction of provisions

The programmed provisions can be reproduced both memory keys, and remote radio control (radio key).

Reproduction by memory keys

 PERFORMANCE ORDER

  1. At an open door of the driver once press the corresponding key of a memory.
  2. At the closed door of the driver press and hold the corresponding key of a memory, so far the seat and external mirrors will not reach the programmed position.

Reproduction by remote radio control

 PERFORMANCE ORDER

  1. Unlock the car remote radio control and within the next 10 minutes open the driver's door.

If after unlocking of the car remote radio control the door of the driver remains closed within 10 minutes, the provision of a seat reproduce memory keys.

Programming of a radio key

For reproduction of the entered provisions by remote radio control it is necessary to program a radio key on a memory key.

Programming of a radio key on a memory key

 PERFORMANCE ORDER

  1. The corresponding key of a memory to which there has to correspond this key, reproduce the programmed provisions.
  2. Press and hold this key and within 10 seconds in addition press the button of unlocking of a radio key.
  3. About 2 seconds of later, release a key.

Cancellation of programming of a radio key on a memory key

 PERFORMANCE ORDER

  1. Press and hold the MEMO key and within 10 seconds in addition press the button of unlocking of a radio key.
  2. About 2 seconds of later, release the MEMO key.

When reprogramming there is an automatic dumping of the previous data.

It is recommended to program that the key 1 corresponded to one, and a key 2 - to other factory radio key. Through the contractual partner of Audi if necessary it is possible to get two more other radio keys and to program on keys 3 and 4.

Head restraints

Head restraints of forward seats

Correctly established head restraints in combination with the fastened seat belt provide effective protection.

Forward seat: head restraint

Raising of a head restraint

 PERFORMANCE ORDER

  1. Undertake head restraint sidewalls both hands.
  2. So adjust the provision of a head restraint that the upper edge of a head restraint was a minimum at the level or higher than a level of eyes.

Lowering of a head restraint

 PERFORMANCE ORDER

  1. Undertake head restraint sidewalls both hands.
  2. Press the button (A), and so adjust the provision of a head restraint that the upper edge of a head restraint was a minimum at the level or higher than a level of eyes.

Regulation of an inclination

 PERFORMANCE ORDER

  1. Undertake head restraint sidewalls both hands and wring out it forward or back.

Removal of head restraints

 PERFORMANCE ORDER

  1. Pull a head restraint against the stop up.
  2. Press the button (B) and take a head restraint.

Installation of head restraints

 PERFORMANCE ORDER

  1. Insert and move head restraint bars in directing until their fixing.

Head restraints are regulated on height and an inclination. They have to be established on growth. Correctly estab