Audi A4, S4
+ Introduction
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
- Coupling, power shafts and differential
+ Coupling
- Power shafts of wheels
General information
Removal and installation of a power shaft
Dismantling of a power shaft and replacement of a protective cover
+ Models with the full drive of wheels
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of a power shaft Removal
|
|
- Take off the cap closing a wheel, a decorative cap or caps of bolts of fastening of wheels.
- Turn off on a corner 90 ° a bolt of fastening of the external hinge of a power shaft.
|
|
|
Weaken a bolt when the car costs on wheels. Danger of accident! |
|
- Note shooters the direction of rotation of wheels. Turn off bolts of fastening of a wheel. Lift and install the car on supports and remove a wheel.
- Again wrap by hand all five bolts of fastening of a wheel.
- Turn out a bolt of fastening of the external hinge of a power shaft.
- Disconnect a power shaft from a flange shaft / check point.
|
- If the sufficient place is not present to take out a power shaft, execute the following: turn off a nut (1), turn off a bolt and take out upward both levers (2).
|
|
|
|
Do not expand a groove in the wheel bearing case by means of a chisel or the tool similar to it. |
|
- Take aside the wheel bearing case.
|
|
|
(3) and (4) do not turn off bolts since in this case adjustment of a forward suspension bracket will change and a running gear it is necessary to regulate again. |
|
- Take out a power shaft.
|
|
Installation
|
|
- Insert a power shaft into the wheel bearing case.
- Install into place both top levers. Establish a new bolt and tighten a new nut the moment 40nm. At an inhaling of a nut press on the suspension bracket lever in the direction of the wheel bearing case as far as it perhaps.
- Fix a power shaft on an axis/check point flange with podkladny plates. Tightening moment: M8 bolt – 40nm, a bolt of M 10 - 70nm.
- Fix the external hinge of a power shaft a new bolt. Tightening moments: M14 bolt – 115nm, M16 bolt – 190nm.
|
|
At a bolt inhaling the car can not concern the basis. |
- Observe the direction of rotation of wheels. Fix a wheel, lower the car on wheels and only after that tighten bolts cross-wise the moment 120nm.
|
|
Address to the subsection "Removal and Installation of a Wheel" of the Section In case of emergency. |
- Ask the assistant to tighten the parking brake.
- Tighten a bolt of fastening of a power shaft, tighten a bolt on a corner 180 °.
- Establish into place the cap closing a wheel, a decorative cap or caps of bolts of fastening of wheels.
|
|
|
|