Audi A4, S4

since 2000 release

Repair and operation of the car



Audi A4, S4
+ Introduction
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
- Cooling systems, heating and air conditioner
   + Cooling system
   - Systems of ventilation, heating and air conditioning
      General information and security measures
      Removal and installation of the air snuffled
      Removal and installation of the electric motor of the drive of the ventilating gate
      Removal and installation of the control unit of the heater/conditioner
      Removal and installation of the electric motor of the drive of the fan of a heater and conditioner
      Removal and installation of the sensor of temperature of external air
      Removal and installation of an additional heating element
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment






Removal and installation of the electric motor of the drive of the fan of a heater and conditioner

The control unit of the fan of fresh air is installed on the electric motor and can act and be replaced only together with the electric motor.

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative cable (-) of the battery.

Observe indications of the Section Replacement of the Battery.

  1. Remove a ware box, address to the Section Removal and installation of a ware box.
  1. Disunite the socket (And).
  1. Release a cable connector (In).
  2. Remove facing on a rack And, address to the Section Removal and installation of facing of a rack And.
  3. Carefully cast away a rug around an arrangement of feet.
  1. Take aside a noise-protective mat and turn out the screw (C).
  1. Take aside a noise-protective mat and take out from a heater the fan (D) with the built-in control unit.

Installation

 PERFORMANCE ORDER

  1. Installation is carried out in sequence, the return to removal.
  2. At installation pay attention to the correct position of the fan in a heater.
  3. Record a cable a connector.











http://b3-b4.ru/