Audi A4, S4

since 2000 release

Repair and operation of the car



Audi A4, S4
+ Introduction
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Specifications
   Diagnostics of malfunctions of onboard electric equipment - the general information
   Rassoyedineniye of sockets
   Check of the electric motor of a screen wiper
   Check of the warmed back glass
   Check of stoplights
   Removal and installation of a sound signal
   Removal and installation of sensors of a parking
   Replacement of the battery of a remote control of the ignition key
   Relay and safety locks
   Replacement of glow lamps of devices of external lighting
   Removal and installation of headlights
   Removal and installation of the lateral repeater of turns
   Removal and installation of an additional stoplight
   Removal and installation of a back lamp
   Removal and installation of a lamp of illumination of registration plate
   Removal and installation of plafonds of internal lighting
   Removal and installation of a control panel
   Removal and installation of the understeering switch
   Removal and installation of switches of a forward door
   Removal and installation of the switch of light
   Removal and installation of the switch of a window regulator in a back door
   Removal and installation of the switch of a trunk lid
   Removal and installation of the switch of the parking brake
   Removal and installation of the switch of illumination of a ware box
   Removal and installation of switches of the central console
   Removal and installation of the radio receiver / navigation device / CD changer
   Removal and installation of loudspeakers
   Removal and installation of antennas
   Removal and installation of the tank of liquid of the windscreen washer/electric motor of the pump
   Removal and installation of the electric motor of screenwash
   Removal and installation of the electric motor on back glass (Station wagon)
   The uniform lock - the general information
   Removal and installation of a locking element of a cover of a fuel tank
   Digital tire of data of CAN
   + Schematic diagrams of electric equipment






Removal and installation of antennas

Sedan

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative cable (-) of the battery.

Observe indications of the Section Replacement of the Battery.

  1. Remove the closing roof level, address to the Section Removal and installation of facing of a forward door.
  1. Disconnect lock clips (arrows on an accompanying illustration) and remove the antenna (1) from a roof.
  1. Disunite the socket (2) antennas.

Installation

 PERFORMANCE ORDER

  1. Installation is carried out in sequence, the return to removal.

Versatile person

Removal

 PERFORMANCE ORDER

  1. Disconnect a negative cable (-) of the battery.

Observe indications of the Section Replacement of the Battery.

  1. Remove a plafond of a cargo compartment, address to the Section Removal and installation of plafonds of internal lighting.
  1. Remove the closing roof level, address to the Section Removal and installation of facings (Station wagon).
  1. Disunite sockets (2) and (3).
  1. Turn off a nut (1) and remove the antenna from a roof.

Installation

 PERFORMANCE ORDER

  1. Further installation is carried out in sequence, the return to removal. Thus carry out an antenna wire through a groove in a washer of a nut (1). Join sockets according to the tags which are available on them.

Antenna of clock radios

Removal

 PERFORMANCE ORDER

  1. Remove a rear bumper, address to the Section Removal and installation of facings (Station wagon).
  1. Disconnect an antenna cable (3) from the antenna (2).
  1. Turn out screws (1) and remove the antenna from the holder of a bumper.

Installation

 PERFORMANCE ORDER

  1. Installation is carried out in sequence, the return to removal.