Audi A4, S4

since 2000 release

Repair and operation of the car


Audi A4, S4
+ Introduction
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Specifications
   Diagnostics of malfunctions of onboard electric equipment - the general information
   Rassoyedineniye of sockets
   Check of the electric motor of a screen wiper
   Check of the warmed back glass
   Check of stoplights
   Removal and installation of a sound signal
   Removal and installation of sensors of a parking
   Replacement of the battery of a remote control of the ignition key
   Relay and safety locks
   Replacement of glow lamps of devices of external lighting
   Removal and installation of headlights
   Removal and installation of the lateral repeater of turns
   Removal and installation of an additional stoplight
   Removal and installation of a back lamp
   Removal and installation of a lamp of illumination of registration plate
   Removal and installation of plafonds of internal lighting
   Removal and installation of a control panel
   Removal and installation of the understeering switch
   Removal and installation of switches of a forward door
   Removal and installation of the switch of light
   Removal and installation of the switch of a window regulator in a back door
   Removal and installation of the switch of a trunk lid
   Removal and installation of the switch of the parking brake
   Removal and installation of the switch of illumination of a ware box
   Removal and installation of switches of the central console
   Removal and installation of the radio receiver / navigation device / CD changer
   Removal and installation of loudspeakers
   Removal and installation of antennas
   Removal and installation of the tank of liquid of the windscreen washer/electric motor of the pump
   Removal and installation of the electric motor of screenwash
   Removal and installation of the electric motor on back glass (Station wagon)
   The uniform lock - the general information
   Removal and installation of a locking element of a cover of a fuel tank
   Digital tire of data of CAN
   + Schematic diagrams of electric equipment





Removal and installation of plafonds of internal lighting

The exhaust hook, for example, 3370 or HAZET 2520-1 is necessary for removal of a plafond of internal lighting. HAZET 1965-20 can apply also plastic wedge to this purpose, for example, (address to an illustration below).

 PERFORMANCE ORDER

  1. Switch off the switch of the corresponding plafond.
  2. Switch off ignition.

Forward ceiling plafond / plafond of illumination for reading

 PERFORMANCE ORDER

  1. Extend a cover of a plafond by means of a hook and remove it.
  1. Turn out screws (arrows on an accompanying illustration).
  1. Lower a forward plafond down and take out from an adjusting aperture in a ceiling.
  2. Disunite the plafond socket.
  3. Installation is carried out in sequence, the return to removal.

Replacement of the glow lamp of a plafond of illumination for reading

 PERFORMANCE ORDER

  1. Press a lamp (1) and (2) into a cartridge, turn and take out. Replace a lamp with the new.

Replacement of the glow lamp of a ceiling plafond

 PERFORMANCE ORDER

  1. Take out by means of a hook the lens of a ceiling plafond and remove it.
  1. Take out a sofitny lamp (1) and (2) of the boss and replace with the new.

Back plafond of illumination for reading

 PERFORMANCE ORDER

  1. Take out by means of a hook a plafond from an adjusting aperture in a ceiling.
  2. Disunite the lamp socket.
  3. Installation is carried out in sequence, the return to removal.

Replacement of the glow lamp

 PERFORMANCE ORDER

  1. Press a lamp from a reverse side of a plafond, turn and take out it. Replace a lamp with the new.

Lamp of illumination of a ware box

Some lamps, for example, a lamp of a door signaling device, the entrance lighting lamp, the forward lighting lamp of the region of feet and the lighting lamp of a luggage carrier (sedan) are taken out similar to a lamp of illumination of a ware box.

 PERFORMANCE ORDER

  1. Lamp of illumination of a ware box: Open a ware box.
  1. Take out a lamp (2) by means of a plastic wedge, for example, of HAZET 1965-20 of an adjusting aperture. Thus put a wedge in a groove. (1) – lock level.
  1. Disunite the socket (3) lamps.
  2. Installation is carried out in sequence, the return to removal. Thus insert a lamp from the plug into an opening and record on the other hand.

Replacement of the glow lamp

 PERFORMANCE ORDER

  1. If necessary, cast away a cover from a reverse side of a lamp up (an arrow on an accompanying illustration).
  1. Take out a lamp from the boss and replace with the new.

Plafond of illumination of a cargo compartment (Station wagon)

 PERFORMANCE ORDER

  1. Take out a plafond by means of a hook from an adjusting aperture in a ceiling.
  1. Disunite the lamp socket.
  1. Installation is carried out in sequence, the return to removal.

Replacement of the glow lamp

 PERFORMANCE ORDER

  1. Put a screw-driver at a groove, hook and remove the lens.
  1. Take out a sofitny lamp from the boss and replace with the new.

Back door plafond (Station wagon)

 PERFORMANCE ORDER

  1. Take out by means of a hook a plafond from an adjusting opening in the direction of the movement of the car (the shooter on an accompanying illustration).
  1. Disunite the lamp socket.
  1. Installation is carried out in sequence, the return to removal. Thus insert a plafond into an opening and an aperture and record it clips.

Replacement of the glow lamp

 PERFORMANCE ORDER

  1. Take out a reflector (1) from a reverse side of a plafond (2) and then a sofitny lamp. Replace a lamp with the new.

Back plafond of lighting of the region of feet

 PERFORMANCE ORDER

  1. Shift a plafond towards outer side of the car (the shooter on an accompanying illustration) and take out it from an adjusting aperture.
  1. Disunite the lamp socket.
  2. Installation is carried out in sequence, the return to removal. Thus insert a lamp into an aperture the shtekerny party.

Replacement of the glow lamp

 PERFORMANCE ORDER

  1. Release lock levels (arrows on an accompanying illustration), hook from a reverse side and uncover.
  1. Take out a lamp from the boss and replace it new.

Plafond of illumination of a cosmetic mirror

 PERFORMANCE ORDER

  1. Put a screw-driver in a groove, hook and take out a plafond from an adjusting opening in a ceiling.
  2. Disunite the lamp socket.
  3. Installation is carried out in sequence, the return to removal. Thus insert a lamp into an aperture behind the shtekerny party and record from a reverse side.

Replacement of the glow lamp

 PERFORMANCE ORDER

  1. Cast away a cover from a reverse side of a plafond (the shooter on an accompanying illustration) and take out a sofitny lamp from the boss. Replace a lamp with the new.

Lighting of the handle of a door

 PERFORMANCE ORDER

  1. Disconnect a negative cable (-) of the battery.

Observe indications of the Section Replacement of the Battery.

  1. Remove a door upholstery, address to the Section Removal and installation of facing of a forward door.
  1. Take out a lamp (1) of the holder on a door upholstery.
  1. Disunite the socket (2) lamps.
  2. Installation is carried out in sequence, the return to removal. Thus insert a lamp into an adjusting aperture and record.