Audi A4, S4
+ Introduction
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
- Suspension bracket and steering
Security measures at work
+ Suspension bracket of forward wheels
+ Suspension bracket of back wheels
+ Corners of installation of wheels of the car
- Steering and safety cushions
General information and security measures
Removal and installation of the block of a safety cushion
Removal and installation of a steering wheel
Removal and installation of a tip of steering draft
Removal and installation of a protective cover of the steering mechanism
+ Body
+ Onboard electric equipment
|
Removal and installation of a tip of steering draft Removal
|
|
- Mark the direction of its rotation on the tire. Turn off bolts of fastening of a wheel. Lift and establish forward part of the car on supports and remove a wheel.
|
- Turn out a bolt (1).
|
|
- Turn off a nut (5) and turn out a bolt (2).
|
|
|
Do not expand vents in the wheel bearing case with a chisel or any other similar tool. |
|
|
Do not apply a chisel or any similar tool to removal of steering draft by its zabivaniye between the pendular lever (1) and a sealing washer (2) tips of steering draft. Steering draft can be removed only by a vypressovka of the end of a pin of a tip from the steering lever or blows of a wooden or rubber hammer. |
|
- Remove steering draft down.
|
|
- Turn off a lock-nut (3) and turn out a tip from steering draft.
|
- Wipe a tip of steering draft and a terminal opening on the wheel bearing case.
|
|
Installation
|
|
- Screw a tip on steering draft against the stop.
- Tighten a lock-nut (3) moment 40nm. HUNDRED AUDIS use for this purpose the V.A.G 1332/12 tool. At an inhaling keep steering draft from a provorachivaniye for a hexagon (4).
- Expose steering draft so that the pin of a tip was in the provision of installation.
|
- Insert steering draft against the stop into the pendular lever.
|
|
|
|
Insert steering draft into the pendular lever (1) only by hand, thus do not press strongly on a sealing washer (2) tips. |
|
- Insert a bolt (2) and screw a new nut (5), tighten a nut the moment 50nm.
|
|
- Establish a bolt (1) and tighten it the moment 7nm.
|
- Establish and fix a wheel, observing the direction of its rotation. Lower the car and only after that tighten bolts cross-wise the moment 120nm.
- Take measurements of a running gear of the car (work HUNDRED).
|
|
|
|