Audi A4, S4
+ Introduction
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
- Suspension bracket and steering
Security measures at work
+ Suspension bracket of forward wheels
- Suspension bracket of back wheels
General information
Removal and installation of a screw spring
Removal and installation of the shock-absorber
+ Corners of installation of wheels of the car
+ Steering and safety cushions
+ Body
+ Onboard electric equipment
|
Removal and installation of a screw spring Removal
|
|
Removal of a screw spring requires the special adaptation. HUNDRED AUDIS use to this purpose the adaptation for compression of V.A.G. 1752/1, V.A.G adapter. 1752/9 and holder of a spring of V.A.G. 1752/16. |
|
|
- Mark with an arrow on the tire the direction of rotation of a wheel. Weaken bolts of fastening of a wheel. Lift and establish back part of the car on supports and remove a wheel.
|
|
- Install on a spring the adaptation for compression of a spring with an adapter and the holder of a spring. If necessary, at first insert the holder of a spring into rounds and then connect him to the adaptation. Thus watch to damaging the trapezoidal lever.
|
|
|
It is necessary to squeeze four rounds. If it is not possible, squeeze three rounds and then turn a spring so that it was possible to squeeze four rounds. Watch the correct provision of a spring in the holder. Danger of accident! |
|
- Squeeze the adaptation against the stop and remove a spring.
|
|
Installation
|
|
- At installation of a new spring watch that the conic end watched it down. Color tags (an arrow B on an accompanying illustration) have to show down.
|
|
- Insert a pin of a support of a spring (1) into an opening of the trapezoidal lever (2).
- Turn the end of a spring so that it lay on an emphasis of a support of a spring (arrow A).
- Insert the top laying of a spring (on an illustration it is not shown) into the top end of a spring.
- Carefully weaken a spring. Thus level the provision of the top laying of a spring.
- Observing the direction of rotation of a wheel, fix a back wheel. Lower the car on wheels and only after that tighten bolts of fastening of a wheel cross-wise the moment 120nm.
|
|
|
|