Audi A4, S4

since 2000 release

Repair and operation of the car

Audi A4, S4
+ Introduction
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
- Manual box of gear shifting
   Removal and check point installation
   Check of level of oil in a manual check point
   Adjustment of the drive of gear shifting
   Check of adjustment of the lever of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Check of level of oil in a manual check point


  1. Install the car on an equal platform.
  2. Lift and install the car on a platform.
  1. Turn out a stopper for filling with oil depending on execution with a face key on 10 mm, for example, with HAZET 985-10 or a face key under a polyhedron, for example, of AUDI-3357 or HAZET 2567-16. The stopper is located at the left on a check point under the sensor of the measuring instrument of speed and can be closed by the heat-shielding screen of a power shaft.
  1. Check oil level by means of the wire bent at an angle. Level of oil has to be 7 mm below than the lower edge of an opening for an oil flood.

Filling also to the level of the lower edge of an opening is allowed. Apply only synthetic oil specified in Specifications.

  1. Tighten a stopper the moment 25nm.

Stopper different for a check point from aluminum and magnesian alloys.