Audi A4, S4
+ Introduction
+ Governing bodies and methods of safe operation
+ Current leaving and service
- Engine
Specifications
Removal and installation of the top cover of the engine / lower protection of a motive compartment / stretcher
Check of a compression in engine cylinders, identification of leaks
Check of the engine by means of the vacuum gage
+ 4-cylinder petrol engines
+ 6-and 8-cylinder petrol engines
- 4-cylinder diesel engines
General information
Removal and installation of a gear belt, engines of 1.9 l (AVB, AWX, AVF)
Natyazhitel of a belt with damping by friction
Removal and installation of a head of cylinders, diesel engines of 1.9 l (AVB, AWX, AVF)
Removal and installation of a belt of the drive of auxiliary units
+ 6-cylinder diesel engines
+ engine Lubrication system
+ Cooling systems, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Natyazhitel of a belt with damping by friction
Weakening of a gear belt
|
|
- Turn off a nut of fastening (1) tension roller.
|
|
- Turn counterclockwise the clown HAZET 2587-1 key so that the tension roller could be recorded a lock finger of T 10115 or similar.
|
- Turn HAZET 2587-1 key clockwise against the stop and tighten by hand a nut (1).
|
|
- Take off a gear belt at first from the pump of cooling liquid and then from other cogwheels.
|
|
Installation
|
|
- Check, whether the tension roller by a lock finger of T 10115 is recorded and whether is recorded by a nut on the right emphasis.
|
|
|
Adjusting works with a gear belt need to be performed only on the cold engine. At turn of a camshaft the stop of any piston in situation VMT is not allowed. Danger of damage of the valves/bottom of pistons. |
|
- Check the provision of a tension roller: The lock pad (an arrow on an accompanying illustration) has to enter a groove on a head of cylinders, and an opposite case it is appropriately necessary to displace the holder.
|
|
- Double-check, whether VMT tags coincide.
|
- Turn off bolts of fastening of a wheel of a camshaft so that the wheel could move in oblong openings.
|
- Establish a wheel in oblong openings in average situation.
|
- Put on a gear belt a camshaft wheel, a tension roller, a wheel of a cranked shaft and in the last turn on a wheel of the pump of cooling liquid.
|
|
Tension of a gear belt
|
|
- Take out a lock finger of T10115.
|
|
- Turn off a nut of fastening (1) tension roller.
- Turn the clown of a tension roller HAZET 2587-1 key in the direction of an hour hand so that the index (2) faced on the center a window of a basic plate.
- Holding a tension roller in this situation tighten a nut of fastening of a tension roller the moment 20nm + 45 °.
- Tighten bolts of fastening of a wheel of a camshaft the moment 25nm.
|
|
|
|