Audi A4, S4

since 2000 release

Repair and operation of the car


Audi A4, S4
+ Introduction
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ Power supply systems, release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Coupling, power shafts and differential
+ Brake system
+ Suspension bracket and steering
- Body
   General information and security measures when carrying out body works
   Cleaning and leaving
   Repair of insignificant damages of body panels
   Repair of considerable damages of a body
   + External equipment
   - Equipment of salon
      Remarks on work with the equipment of salon and a security measure
      Removal and installation of spring clips
      Removal and installation of the central console
      Removal and installation of the holder of drinks
      Removal and installation of facing of the lever of the parking brake
      Removal and installation of a cover of the lever of switching of transfers/selector
      Removal and installation of an ashtray
      Removal and installation of the central armrest
      Removal and installation of an internal mirror
      Removal and installation of a cover on a control panel
      Removal and installation of a pocket from the driver
      Removal and installation of a ware box
      Removal and installation of an antisolar peak
      Removal and installation of facing are permanent And
      Removal and installation of the top facing of a rack In
      Removal and installation of the lower facing of a rack In
      Removal and installation of a forward overlay of a threshold
      Removal and installation of facings (Sedan)
      Removal and installation of facings (Station wagon)
      Removal and installation of a forward seat
      Removal and installation of a back seat
      Removal and installation of a forward seat belt
      Removal and installation of a back seat belt
+ Onboard electric equipment





Removal and installation of a forward seat belt

Removal

 PERFORMANCE ORDER

At a detachment of cables of system of a safety cushion surely observe security measures at the address with a safety cushion, address to the Section General information and security measures.

Remember the provision of installation of a seat belt since there can be various options.

  1. To exclude operation a head safety cushion, switch off ignition and disconnect at first the negative (-), and then positive battery room cables
  2. Disconnect facing of a rack And around a rack In, address to appropriate section.
  3. Disconnect facing of a rack D/facing over a back door (Station wagon) around a rack In, address to appropriate section.
  4. Remove facing of a rack In above and below, address to appropriate section.
  1. Remove a seat belt (1) at a forward seat, address to the Section Removal and installation of a forward seat.

The arrow A on an accompanying illustration shows in the direction of the movement of the car. (2) – a belt tip, (5) – directing a belt.

  1. Turn out the screw (4) and take out the device for taking-up of a belt (3).
  2. Extend a screw-driver a yellow safety level and disunite the yellow-blue socket (9).
  3. Turn out the screw (7) and disconnect a belt (1) from the regulator of height (6). (8) - bolt of fastening of the regulator of height, 23nm.

Installation

 PERFORMANCE ORDER

Do not press a lock key (10) of the regulator of height of a belt in an installation time.

  1. Installation is carried out in sequence, the return to removal.
  2. If at a certain execution of a belt the lock uvula in not a working condition of a belt is directed towards a rack In, it is necessary to turn a belt tape at installation on 180 ° (an arrow on an illustration higher).
  3. Tighten bolts (4) and (7) moment 55nm.
  4. Check operation of the regulator of height of a belt, address to the Section Removal and installation of the top facing of a rack of Century.

During connection of the battery in salon there should not be people.

  1. Remove the isolating tape from a negative pole of the battery, attach at first positive (+), and then a negative cable (-) to the battery.

Observe indications of the Section Replacement of the Battery.